Impact of rail joints on the local stresses in crane runway girders

Vertically acting wheel loads from overhead bridge cranes and potential additional horizontal crane loads induce global stresses due to bi-axial bending and torsion and local stresses in crane runway girders which mainly affect the girder’s web. The latter typically represent one of the most decisive criteria for the fatigue design check of welded girders and are the focus of this paper. Crane rails with foot flange are typically used for moderate to high wheel loads. They are usually connected to the top flange with rail clips. Rails with foot flange are used with and without elastomeric bearing pads between the rail and the top flange of the girder. The local stresses in the webs of crane runway girders are strongly affected by discontinuities of the crane rails. Such discontinuities can originate from unplanned rail cracks as well as planned rail expansion joints. The current mechanical models for concentric as well as eccentric wheel loading in relevant design standards assume continuous crane rails. However, rail joints are expected to significantly increase the local stresses in the region beneath rail joints. The present paper focuses on the impact of rail joints on the local stresses in crane runway girders. The research activities comprise experimental tests as well as numerical parametric studies based on finite element calculations, both for rails with and without elastomeric bearing pads. The aim of the investigations is to develop a better understanding of the mechanical behaviour and to quantify the increase factor for maximum local stresses in order to avoid future fatigue damage due to an unexpected increase of local stresses at a rail joint.