High temperature mechanical properties and microstructure of Ti–Nb–Zr–Ta–O biomedical alloy

D. Preisler*, J. Stráský, P. Harcuba, F. G. Warchomicka, M. Janeček

*Corresponding author for this work

Research output: Contribution to journalArticlepeer-review


Sufficient biocompatibility and high strength are fundamental properties required for total joint endopros-theses material. Recently developed Ti-based alloy Ti–35.3Nb–7.3Zr–5.7Ta–0.7O (wt%) exhibits these properties. However, the as-cast material does not meet requirements for fatigue resistance due to pores and very coarse grain structure and therefore a feasible forming procedure must be established. Gleeble apparatus was used to deform the studied alloy at high temperatures (from 800C to 1400C) and high strain rates (up to 1 s 1) to the total strain of 0.5. Mechanical properties at elevated temperatures were evaluated. The resulting microstructure was investigated by scanning electron microscopy and electron backscatter diffraction (EBSD). It was found that forming procedure should be performed at temperatures higher than 1400C to reach conditions similar to forming of Ti–6Al–4V. Calculation of kernel average misorientation from EBSD data showed that most deformation is stored in the material in the vicinity of grain boundaries without any apparent recrystallization.

Original languageEnglish
Pages (from-to)636-639
Number of pages4
JournalActa Physica Polonica A
Issue number3
Publication statusPublished - 1 Sept 2018

ASJC Scopus subject areas

  • Physics and Astronomy(all)

Cite this